Replace Gasket Ring For Inner Drive Shaft - Skoda FABIA II 2007 Workshop Manual

– Drive in new shaft seal so that it is flush with the clutch housing.
Use a plastic hammer for this purpose.
• The shoulder -arrow- on the pipe section - MP3-450- points
upwards.
Note
If the inner drive shaft is installed, position the pipe - T30055
(3296)- onto the pipe section - MP3-450- if necessary.
Caution
Touch the gasket ring until flush to ensure the oil bore under‐
neath is not blocked In this case, the bearing is not given a
sufficient supply of oil.
– Install the clutch release mechanism
⇒ "1.2 Removing and installing clutch release mechanism",
page 34 .
– Install double clutch
2.5

Replace gasket ring for inner drive shaft

Special tools and workshop equipment required
♦ Gasket ring extractor - T10420-
♦ Thrust piece - T10421-
2 shaft seals are located in the gearbox -arrows- on the clutch
side. Both seals can be replaced without disassembling the gear‐
box. If only the shaft seals are replaced, the double clutch must
not be adjusted.
In the event of a gearbox drive shaft "Leaks" error, the condition
of the engine crankshaft sealing flange on the gearbox side must
also be checked.
• Double clutch gearbox removed
⇒ "2.2 Remove double clutch", page 66
• Clutch release mechanism is removed
⇒ "1.2 Removing and installing clutch release mechanism",
page 34
Caution
If there are leaks, you must check the double clutch. If the
double clutch is covered in oil, it will need to be replaced.
– Release the spindle of the gasket ring extractor - T10420- .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
⇒ "2.3 Install double clutch", page 69
Gearbox 0AM-DSG - Edition 01.2015
.
75
2. Clutch