Skoda FABIA II 2007 Workshop Manual page 552

Press outer ring/tapered-roller bearing into the clutch housing
No adjusting washer is fitted at the side of the clutch housing.
Removing inner ring/tapered-roller bearing
– Before fitting the extractor, position the thrust plate -MP3-467
(40-105) - on the differential gear housing.
Note
Both inner rings/tapered-roller bearings of the differential gear
housing are removed in the same way.
Press on inner rings/tapered-roller bearing
Note
The inner rings/tapered-roller bearings for the gearbox housing
and clutch housing are pressed on with the same special tools.
Remove outer ring/tapered-roller bearing from gearbox housing
A - Countersupport , e.g. -Kukko 22/2-
B - Interior extractor 46...58 mm , e.g. -Kukko 21/7-
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
2. Differential gear
155