Inspecting The Gearshift Mechanism - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
10 - Screw
❑ for cable support to gearbox
❑ 2 pieces
❑ 23 Nm
11 - Selector lever control cable
❑ The selector lever control cable must not be removed from the shift mechanism Pos. 4 and must be
replaced together as one component part.
❑ when installing in the vehicle, clamp on the gearbox side with the fixing part to the heat shield of the
exhaust system
❑ Do not grease selector lever control cable
12 - Support
❑ for selector lever control cable
13 - Nut
❑ for holder Pos. 12 at gearbox
❑ 13 Nm
Remove the shift mechanism together with the selector lever con‐
trol cable from the shift housing
Remove the shift mechanism -A- together with the selector lever
control cable -C- from the shift housing -B- in
-direction of arrow-. To do so, unscrew the 4 screws Pos. 5.
2.2

Inspecting the gearshift mechanism

♦ In selector lever positions S, D, R and Tiptronic position it must
not be possible to activate the starter.
♦ At speeds above 5 km/h and shifting in selector lever position
N, the selector lever lock solenoid must not engage and block
the selector lever. Selector lever can be shifted in a driving
position.
♦ At speeds below 5 km/h (virtual standstill) and shifting in se‐
lector lever position N, the selector lever lock solenoid must
only engage after approx. 1 s. The selector lever can only be
shifted from position N by activating the brake pedal.
Selector lever in position P, button on selector lever pressed and
ignition switched on
• Brake pedal is not operated.
The selector lever is locked when the button is pressed and can‐
not be shifted out of position P.
The selector lever lock solenoid blocks the selector lever.
• Brake pedal is operated.
The selector lever lock solenoid releases the selector lever. It is
possible to engage a driving gear position. Slowly shift selector
lever from P through R, N, D, S; while doing so check whether the
selector lever position in the dash panel insert corresponds with
the actual selector lever position.
104
Rep. gr.34 - Controls, housing