Replacing The Right Flange Shaft Seal Ring - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Drive in the new gasket ring with thrust piece - T30028 (3305)-
up to the stop, do not twist the new gasket ring.
– Insert the flange shaft.
– Tighten new conical screw to the specified tightening torque.
– Attach the left drive shaft to the flange shaft ⇒ Chassis; Rep.
gr. 40 .
– Change gearbox oil
Note
The gearbox oil must be changed, only in this way the correct gear
oil level can be ensured.
– Install left front wheel ⇒ Chassis; Rep. gr. 44 .
– If the front left vehicle level sensor - G78- was removed, check
headlight beam setting ⇒ Electrical System; Rep. gr. 94 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Tightening torque
Component
Flange shaft on gearbox (conical screw)
1.5

Replacing the right flange shaft seal ring

Special tools and workshop equipment required
♦ Socket insert - T10107A- or socket insert 6 mm, commercially
available
♦ Extractor tool - T20143-
♦ Thrust piece - T30028 (3305)-
♦ Tensioning strap - T10038-
♦ Sealing grease - G 052 128 A1-
♦ Catch pan
Removing
• Observe the general repair instructions
⇒ "3 Repair instructions", page 4
• Do not undo the two securing bolts in the left and right flange
shafts at the same time, and do not remove both flange shafts
from the gearbox at the same time. If the differential bevel
gears twist, it will be difficult to reinstall the flange shafts.
– Shift selector lever into position P.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
188
Rep. gr.39 - Final drive - differential
⇒ "5 Change gearbox oil", page 174
⇒ "1.1 Summary of components - gasket rings and output shafts",
.
.
Nm
page 178