Skoda FABIA II 2007 Workshop Manual page 1114

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
and the tolerances in the clutch determine the thickness of the
adjusting washer.
Conditions
• Double clutch gearbox removed
⇒ "2.2 Remove double clutch", page 66
• The mechatronics is installed.
• Only use proper tools.
• The flange of the clutch housing must be free of irregularities,
as the only way to ensure good contact with the straightedge.
• The order of work steps must be observed!
Caution
Risk of damage to the clutch as well as to other components.
Bearing of the engaging lever and the entire engaging bearing
mechatronics must be dry and free of oil and grease.
Removing and installing the ball pin
– Remove the ball pin with the pliers.
– Install a new ball pin.
Note
Press in the ball pin by hand, if necessary slightly drive in with a
plastic hammer (in order not to damage the ball pin).
52
Rep. gr.30 - Clutch