Skoda FABIA II 2007 Workshop Manual page 1122

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Insert the small engaging bearing.
The small engaging bearing fits in only one position due to the 8
grooves.
– While turning, check if the small engaging bearing is correctly
installed and the grooves are correctly positioned.
• Do not insert an adjusting washer!
– Position the gauge block - T10466- on the small engaging
bearing.
• The flat side faces upwards.
– Press on the gauge block - T10466- , and simultaneously ro‐
tate to ensure correct seating.
• The gear shift bearing rotates with the gauge block - T10466- .
– Attach the digital depth gauge upwards on the straightedge
and place the rod of the depth gauge on the outer driveshaft.
• The straightedge - T40100- is already positioned upright on
the flange of the clutch housing.
Caution
The straightedge - T40100- must remain in this position during
the following measurements.
Do not turn or remove it.
– Perform null balance of the digital depth gauge .
60
Rep. gr.30 - Clutch