Skoda FABIA II 2007 Workshop Manual page 1186

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Expose the selector lever control cable -A- from the gearbox
shift lever with the removal tool for the inner lining of the door
panel -MP8-602/1- .
– Remove the lock washer -arrow- of the selector lever control
cable, the selector lever control cable must be left in the fitting
position.
Note
The lock washer -arrow- of the selector lever control cable
♦
must always be replaced ⇒ Electronic Catalogue of Original
Parts .
Do not bend or buckle selector lever control cable.
♦
– Raise vehicle.
– Remove the rear tunnel bridge -1- and the front tunnel bridge
-2- from the body (if present).
– Detach the bracket -3- for exhaust system from the assembly
carrier.
– Slacken clamping sleeve -4-.
Note
The aid of a 2nd mechanic is required to remove the rear silencer.
Caution
The decoupling element in the pre-exhaust pipe should not be
bent by more than 10° - risk of damage.
– Remove the rear part of the exhaust system -5- as from the
clamping sleeve ⇒ Engine; Rep. gr. 26 .
– Slacken the trim panels for the underfloor on left -6- and right
-7- from the body.
– Unclip lambda probe cable at heat shield.
124
Rep. gr.34 - Controls, housing