Skoda FABIA II 2007 Workshop Manual page 1150

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Remove the lock washer -arrow- of the selector lever control
cable, the selector lever control cable must be left in the fitting
position.
– Carefully push the selector lever control cable to the rear, re‐
move it from the cable support and tie up.
Note
The lock washer -arrow- of the selector lever must always be
♦
replaced.
Do not bend or buckle selector lever control cable.
♦
Gearbox removed
– Press the lever in -direction of arrow- by hand up to the stop
and shift the gearshift lever to position P.
The gearbox is installed or removed
– Remove gearshift lever.
– Remove cover.
Caution
The mechatronics will no longer clamp at the next work step.
This means, it will malfunction under certain circumstances. If
not yet performed, the mechatronics must be secured at the
gearbox with a screw against falling down.
– Push the shift lever to the side through the opening in the
-direction of arrow-.
By doing so, the jammed gear actuator is now pressed back and
the mechatronics can be removed.
– Clean the sealing surface on the gearbox and the cover.
– Grease the shaft seal in the cover with sealing grease - G 052
128 A1- .
Note
Replace the screw of the gearshift lever after removal.
88
Rep. gr.34 - Controls, housing