Skoda FABIA II 2007 Workshop Manual page 1110

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Position the gauge block - T10374- with the large opening up‐
wards on the small bearing.
– Lay the straightedge - T40100- at a right angle over the shaft
end onto the gearbox flange.
– Attach the digital depth gauge upwards on the straightedge -
T40100- and place the rod of the depth gauge onto the outer
driveshaft.
– Perform null balance of the digital depth gauge .
Caution
The straightedge - T40100- must remain in this position during
the following measurements.
Do not turn or remove it.
– Place the rod of the depth gauge on the gauge block -
T10374- , as shown in the figure.
– Measure the distance of A2 from the shaft end to the gauge
block - T10374- .
48
Rep. gr.30 - Clutch