Skoda FABIA II 2007 Workshop Manual page 1099

• The small engaging bearing fits in only one position due to the
4 grooves.
– While turning in -direction of arrow-, check if the small engag‐
ing bearing is correctly installed and the grooves are correctly
positioned.
– Fix adjusting washer for K1 -A- with 3 drops of adhesive - AMV
195 KD1 01- -arrows- on the bearing.
This prevents that the washer slips out of its position when the
clutch is inserted.
Specified torques
♦ Small engaging lever with clamp on gearbox
⇒ "1.1.1 Summary of components - Clutch release mecha‐
nism, version up to 05.2011", page 32
1.2.2 Removing and installing clutch release
mechanism, version as of 06.2011
Caution
When replacing the double clutch, the following parts must al‐
ways be replaced too:
♦ the two engaging levers with engaging bearings
♦ Ball pin of the engaging lever for clutch K2
♦ Shims for engaging bearing
After replacing the double clutch and the corresponding parts,
the position of the engaging bearings for clutches K1 and K2
will always
⇒ "1.3.2 Adjusting the clutch release mechanism, gearbox as
of 06.2011", page 51 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
require
Gearbox 0AM-DSG - Edition 01.2015
re-adjusting
37
1. Clutch operation