Working With Testing Devices - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
♦ Specified torques given are for unlubricated nuts, bolts and
screws.
♦ Clean the thread of the screws that are inserted with a locking
agent with a wire brush. Insert bolts with locking agent - AMV
185 101 A1- .
♦ Clean all threaded holes into which bolts are screwed in with
locking agent, using a thread tap to remove locking agent res‐
idues. Otherwise there is a danger of bolts shearing when
subsequently being removed.
♦ Always replace the self-locking screws and nuts.
3.6

Working with testing devices

♦ Vehicle diagnosis, measurement and information system -
VAS/ODIS-
Work in the operating modes
geted fault finding
Adapt information regarding lining
The mechatronics detects the other control units in the vehicle via
the signals in the CAN bus. If the button
is pressed, the mechatronics receives a
regarding lining
command to forget all systems with which it can communicate.
However, after switching on the ignition all active systems with
which it can communicate are detected.
No faults can be generated with this function. The function
information regarding lining
following operations:
♦ After installing the mechatronics.
♦ After the gearbox has been fitted.
♦ After installing the selector lever.
♦ After installing another control unit, for example the engine
control unit, the ABS control unit or the diagnostic interface for
data bus (Gateway).
Vehicles Octavia II, Superb II and Yeti
♦ After working on the steering column gearshift.
Perform basic setting
The mechatronics memorises important settings in the function
COMPLETE BASIC SETTING
memorised, e.g reset to preprogrammed points. For example, the
synchronisation points and the vertices for the engaging lever and
gear switches.
– Button
COMPLETE BASIC SETTING
♦ after interrogating with "Targeted fault finding",
♦ after rectifying the fault stored in the event memory,
♦ after installing the clutch,
♦ or after installing the Mechatronics.
10
Rep. gr.00 - Technical data
targeted functions
.
adapt information
is always carried out after the
. The important settings are also
only functions:
and
tar-
adapt