Skoda FABIA II 2007 Workshop Manual page 1218

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Unscrew the fixing screws -arrows- for the console on the
gearbox.
– Remove the gearbox console.
The gearbox mount - 3282- is placed on the engine/gearbox jack
- V.A.G 1383 A- and is aligned using the adjusting plate - 3282/59-
to remove the gearbox.
– Align arms of the gearbox mount - 3282- to match the holes in
the adjusting plate - 3282/59- .
– Screw in the mounting elements as shown on adjusting plate
- 3282/59- .
– Position the engine/gearbox jack - V.A.G 1383 A- below the
vehicle with the gearbox mount - 3282- .
• The arrow symbol on the adjusting plate - 3282/59- points in
the direction of travel.
– Align the gearbox mount - 3282- parallel to the gearbox.
– Screw the bolt - 3282/29- into the gearbox.
– Place both remaining mounting elements on the gearbox as
shown.
• To do so, place the panel of the drift under the gearbox hous‐
ing and not under the mechatronics.
– Secure the gearbox with the tensioning strap - T10038- .
– Support the gearbox with engine/gearbox jack - V.A.G 1383
A- from underneath.
– Unscrew the last connecting screw -arrow- at engine and
gearbox.
– Separate the gearbox from the engine and carefully lower it.
– When lowering the gearbox, guide the selector lever control
cable out of the cable support.
Caution
Observe all lines and coolant hoses when lowering the gear‐
box.
Do not bend or buckle selector lever control cable.
Vehicles with flange shafts (as of 11.2008)
– Reinstall the right flange shaft.
Continued for all vehicles
156
Rep. gr.34 - Controls, housing