Skoda FABIA II 2007 Workshop Manual page 1189

– Screw the gear shift housing onto the shift mechanism
-arrows-.
– Carefully press the selector lever control cable -2- onto the
gearshift lever and secure in the cable support with a new lock
washer -1-.
– Shift selector lever from S to P.
• Gearshift mechanism and selector lever control cable must
move smoothly when shifting gears.
– Setting selector lever control cable
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 105 .
– Inspect gearshift mechanism
⇒ "2.2 Inspecting the gearshift mechanism", page 104
– Install air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep. gr.
23 .
– Install the heat shield below the shift mechanism and fasten
the trim panels for the underfloor on the body ⇒ Body Work;
Rep. gr. 50 .
– Install exhaust system and align free of stress ⇒ Engine; Rep.
gr. 26 .
– Install the tunnel bridges below the exhaust system ⇒ Engine;
Rep. gr. 26 .
Specified torques
♦ ⇒ "2.1.1 Summary of components - Gearshift mechanism up
to 05.2009 - (Octavia II, Superb II, Yeti)", page 97
2.10 Emergency release of gearshift mecha‐
nism out of position P
Selector lever lock solenoid - N110- locks the selector lever in
position P.
The selector lever can only be shifted out of P when the ignition
is on or the engine is started, the brake pedal is actuated and the
button on the selector lever handle is pressed.
If there are faults in the voltage supply to the selector lever lock
solenoid (battery discharged or fuse defective) or in case of de‐
fective solenoids, the selector lever cannot be moved out of the
position P; i.e. the vehicle cannot be moved because the parking
position is engaged.
If this is the case:
– Test fuse ⇒ Current flow diagrams, Electrical fault finding and
Fitting locations.
– Check the battery voltage ⇒ Electrical System; Rep. gr. 27 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
.
127
2. Shift mechanism