Skoda FABIA II 2007 Workshop Manual page 1220

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
Gearbox with different output shafts:
A - Rigid shafts up to 11.2008
B - flange shafts as of 11.2008
– Shift selector lever into position P.
• Do not take out ignition key.
– If present, remove engine cover ⇒ Engine; Rep. gr. 10 .
– Remove air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep.
gr. 23 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
– Use disassembly tool for inner door trim panel -MP8-602/1- to
release selector lever linkage-A- from the gearshift lever.
– Remove the lock washer -arrow- of the selector lever control
cable, the selector lever control cable must be left in the fitting
position.
• The lock washer -arrow- of the selector lever control cable
must always be replaced ⇒ Electronic Catalogue of Original
Parts .
• Do not bend or buckle selector lever control cable.
• Do not press the selector lever control cable out of the cable
support towards the rear. The selector lever control cable is
only guided out of the cable support once the gearbox was
removed.
– Removing starter ⇒ Electrical System; Rep. gr. 27 .
– Remove the earth cable from the holding down bolt of the
gearbox console.
– Release all the upper connecting screws of the gearbox/en‐
gine.
To this end, use if necessary socket insert - T10035- or socket
insert - T10061- .
158
Rep. gr.34 - Controls, housing