Skoda FABIA II 2007 Workshop Manual page 1221

On some engines, one of the screws is located in the assembly
opening for the starter -arrow-.
– Unscrew engine/gearbox connecting screw -arrow-.
Caution
♦ Under no circumstances must the plug contacts in the plug
of the gearbox be touched with the hands, because the
control unit can be destroyed through static discharge as
well as the mechatronics.
– Grab with the hand (without gloves) at the mass, in order to
discharge yourself electrostatically.
– Unlock the cap of the plug on the mechatronics by pulling in
-direction of arrow- and disconnect the plug.
– Remove the cooling water tank cover ⇒ Body Work; Rep. gr.
66 .
– Position supporting device - T30099- with base - T30099/1- .
Support supporting device - T30099- with base - T30099/1- and
lock carrier.
– Position original spindle -A- on adapter - MP9-200/3 (10-222A/
3)- and hook it into the front engine lifting eye.
In order for the spindle -B- of the supporting device - MP9-200
(10-222A)- not to touch the front flap, it must be shortened to the
dimension -x- (100 mm).
Reduce length of support bracket spindle - MP9-200/10
(10-222A/10)- by 100 mm
I - Original spindle MP9-200/10 (10-222A/10)
♦ Dimension -a- = 442 mm
♦ Dimension -x- = 100 mm
II - shortened spindle MP9-200/10 (10-222A/10)
♦ Dimension -b- = 342 mm
– Position the shortened spindle -B- on the rear adapter -
MP9-200/3 (10-222A/3)- .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3. Removing and installing the gearbox
159