Skoda FABIA II 2007 Workshop Manual page 1133

– Position the extractor onto the clutch.
– Insert the clutch with extractor - T10373- into the gearbox and
then remove the extractor.
– Position the supporting bridge - T10323- parallel to the flange
of the clutch housing.
– Equalise distances, e.g. using washers -B- with a total thick‐
ness of 15 mm.
– Secure the supporting bridge - T10323- with screws -A- and
nuts.
– Press the clutch downwards via the spindle as far as it will go.
During press-in procedure, place a hand onto the clutch. A slight
rattling can be felt. Rattling means that the clutch is pressed onto
its press seat. The stop should be felt in this way when the clutch
has reached its seat.
• The clutch is pressed in up to the stop if the circlip can be
inserted.
– Hold the circlip with the circlip pliers, as shown in the figure.
• Fitting position of the circlip: The narrower impact side of the
circlip facing upwards.
– Insert the new circlip -arrow-.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
71
2. Clutch