Skoda FABIA II 2007 Workshop Manual page 1129

Detach the clutch upwards when the gearbox is removed. The
mechatronics remains on the gearbox.
If a new clutch is installed, the positions of the engaging bearings
for clutches K1 and K2 must be determined and adjusted
⇒ "1.3 Adjust clutch release mechanism", page 41
Then the clutch is pressed onto the drive shaft.
When installing a clutch, most mechanics press the clutch onto
the drive shaft up to the stop. This is not the optimum position of
the clutch!
After installation, the clutch is therefore pulled slightly upwards
against the circlip.
Caution
Risk of damage to the adjusting device of the clutch.
♦ The clutch is self-adjusting. Vibrations can have a nega‐
tive effect on the adjusting device. Therefore do not let the
clutch fall. Do not let the clutch fall into the gearbox when
installing it.
♦ A clutch that has been dropped on a hard surface, or which
is otherwise damaged, must no longer be installed.
♦ Similarly when the mechatronics is removed, the removal
of the drifts below the engaging levers can have a negative
effect on the adjusting device.
• Gearbox removed
⇒ "3 Removing and installing the gearbox", page 132
• Gearbox attached to assembly stand
⇒ "4 Transport the gearbox and secure to the assembly sup‐
port", page 172
• The mechatronics for double clutch gearbox - J743- is installed
on the gearbox
– Detach both ventilation caps -arrows- and close in an oil-tight
manner with suitable screw plugs.
Caution
The ventilation cap on the mechatronics is damaged when re‐
moved and must be replaced!
The oil filling in the area with the hydraulic oil for mechatronics
can not be checked. Before assembly work, the ventilation of
the mechatronics must be sealed oil-tight.
The oil escaping from the area with hydraulic oil for mecha‐
tronics cannot be refilled nor checked. In the event of an oil
loss, the mechatronics must be replaced!
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
.
67
2. Clutch