Skoda FABIA II 2007 Workshop Manual page 1056

Removing
Note
⇒ "2 Information and repair instructions for the automatic gearbox
09G", page 12 .
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Remove drive shaft, right ⇒ Chassis, axles, steering; Rep. gr.
40 .
– Close opening for drive shaft at gearbox with a clean cloth
-A-.
– Position drip tray, e.g. -VAS 6208- under the gearbox.
– Drill a hole in the outer metal plate ring of the shaft seal with
a commercially available twist drill -B- (∅ 2 to 4 mm).
Note
Only drill through the metal plate ring, otherwise the gearbox
♦
may be damaged.
Grease drill -B- in such a way that the metal swarfs adhere.
♦
– Screw a sheet metal screw with a diameter of approx. 4 mm
into the drilled hole of the gasket ring -arrow-.
Note
The sheet metal screw must not be screwed in too deep, so that
the bearing behind the gasket ring is not damaged.
– Remove the gasket ring with the extractor - T10055- and
adapter - T10055/2- .
If the metal plate ring of the gasket ring is pulled out:
– Lever out the remaining shaft seal with a screwdriver -A-.
– Remove cloth -A- and thoroughly clean the gearbox.
WARNING
No metal swarfs must enter into the gearbox and into the open‐
ing for the drive shaft, if necessary suction off these swarfs.
Install
Installation is carried out in the reverse order. Pay attention to the
following:
– Coat the exterior area with ATF and half fill the space between
the sealing lips with sealing grease - G 052 128 A1- .
• Fitting position: The open side of the gasket ring faces towards
the gearbox.
– Position new seal ring by hand and press in as far as possible,
so that the shaft seal is fixed in the gearbox housing.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
1. Replace the flange shaft gasket rings
191