Bringing The Mechatronics For Double Clutch Gearbox J743 To The Removal Position By Hand - Skoda FABIA II 2007 Workshop Manual

– Make sure that no oil flows out of the ventilation -arrow- (close
the ventilation opening with a suitable screw plug).
The new double clutch gearbox mechatronics - J743- is filled with
recycled oil.
Install mechatronics on installed gearbox
⇒ "1.4 Install mechatronics for double clutch gearbox J743 ; gear‐
box installed", page 89
1.3 Bringing the mechatronics for double
clutch gearbox - J743- to the removal
position by hand
Special tools and workshop equipment required
♦ Sealing grease - G 052 128 A1-
It is possible that the mechatronics cannot be removed. In this
case, the gear actuator -arrow- jams on the gearbox housing.
If the removal position could not be set with the vehicle diagnosis,
measurement and information system - VAS/ODIS- , the mecha‐
tronics must be brought to the removal position by hand.
The jammed gear actuator must now be pressed by hand into the
removal position. To do so, remove the cover on the gearshift
shaft.
Gearbox installed
• The mechatronics is located in the gearbox housing and is
secured with a screw.
– Shift selector lever into position P.
Vehicles Octavia II, Superb II, Yeti and Rapid NH
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 (if they were not yet removed).
Vehicles Fabia II and Roomster
– Remove air filter housing complete with air guide hose ⇒ En‐
gine; Rep. gr. 24 .
Continued for all vehicles
– Expose the selector lever control cable -A- of the gearbox shift
lever with the removal tool for the inner lining of the door panel
-MP8-602/1- (if it has not yet been removed).
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 0AM-DSG - Edition 01.2015
1. Mechatronics for double clutch gearbox J743
87