Skoda FABIA II 2007 Workshop Manual page 1251

– Remove the protective cap for right drive shaft from the engine
-arrows-.
– Remove right drive shaft from flange shaft ⇒ Chassis; Rep.
gr. 40 .
Caution
The drive shaft must not hang down, because overstretching
will cause damage to the inner joint.
– Tie up the drive shaft as far as possible. Avoid damaging the
paintwork on the drive shaft during this operation.
– Position the catch pan under the gearbox.
– Unscrew screw for flange shaft with socket insert - T10107A-
or commercially available socket insert 6 mm.
– Take out the flange shaft.
– Remove the gasket ring of the flange shaft e.g with extractor
tool - T20143- or tyre iron.
Installing
– Lightly oil new gasket ring at outer surface.
– Fill half the space between the sealing lip and dust lip with
sealing grease - G 052 128- .
Caution
When driving in the gasket ring with the thrust piece - T30028
(3305)- , ensure that the gasket ring for the flange shaft rea‐
ches its stop in the gearbox before the thrust piece - T30028
(3305)- reaches its stop.
Therefore, the thrust piece - T30028 (3305)- must never be
driven fully into the gearbox housing!
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
1. Replace gasket rings for rigid shafts and flange shafts
189