Skoda FABIA II 2007 Workshop Manual page 951

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Unlock the quick-release lock -3- at the mounting bracket -2-
and unhook the selector lever control cable -1-.
– Remove the circlip -5- and release the selector lever control
cable -1- from the support -4-.
Caution
Risk of damage to the selector lever control cable.
♦ Do not press the selector lever control cable out of the
cable support towards the rear. The selector lever control
cable is only guided out of the cable support when remov‐
ing the gearshift mechanism.
♦ Do not bend or buckle selector lever control cable.
– Raise vehicle ⇒ Maintenance ; Booklet Octavia III .
– Remove the rear tunnel bridge -1- and the front tunnel bridge
-2- from the body (if present).
– Detach the bracket -3- for the exhaust system from the as‐
sembly carrier.
– Slacken clamping sleeve -4-.
Note
The decoupling element in the pre-exhaust pipe should not be
♦
bent by more than 10° - risk of damage.
The aid of a 2nd mechanic is required to remove the rear si‐
♦
lencer.
– Remove the rear part of the exhaust system -5- as from the
clamping sleeve ⇒ Engine; Rep. gr. 26 .
– Slacken the trim panels for the underfloor on left -6- and right
-7- from the body.
– Unclip lambda probe cable at heat shield.
– Remove the heat shield below the shift mechanism towards
the rear, to do so slacken the clips -arrows-.
Note
A second mechanic is needed under the vehicle to remove the
shift mechanism.
86
Rep. gr.37 - Controls, housing