Skoda FABIA II 2007 Workshop Manual page 1168

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
• The selector lever must automatically jump back again to po‐
sition P.
If this is not the case, then the gearshift mechanism must be set
⇒ page 106 .
– Push selector lever to position N.
– Pull selector lever approx. 5 mm back out of position N with
the button pressed and hold, but do not shift into position D.
– Release the selector lever.
• The selector lever must automatically jump back again into the
position "N"
If this is not the case, then the gearshift mechanism must be set
⇒ page 106 .
– Pull selector lever forward approx. 5 mm out of position N with
the button pressed and hold, but do not shift into position R.
– Release the selector lever.
• The selector lever must automatically jump back again into the
position "N"
If this is not the case, then the gearshift mechanism must be set
⇒ page 106 .
Adjusting selector lever control cable
The selector lever control cable must always be set, if:
♦ the selector lever control cable was removed from the gear‐
box.
♦ Remove and install engine and (or) gearbox.
♦ Removed and installed parts of the unit mounting.
♦ the selector lever control cable or the shift mechanism was
removed and installed.
♦ the position of the engine/gearbox was changed, e.g. during
a stress-free adjustment of the assembly bracket.
– Remove air filter ⇒ Engine; Rep. gr. 24 or ⇒ Engine; Rep.
gr. 23 .
106
Rep. gr.34 - Controls, housing