Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
♦ Replace the self-locking nuts and screws when undertaking
assembly work.
♦ Replace screws which have been tightened to a torquing angle
as well as gasket rings and seals.
♦ Secure all hose connections with hose clamps which comply
with the series design ⇒ Electronic Catalogue of Original
Parts .
♦ All cable straps which are detached or cut open when remov‐
ing, should be fitted on again in the same place when installing.
♦ The lock washer of the selector lever control cable must al‐
ways be replaced ⇒ Electronic Catalogue of Original Parts .
♦ Replace the needle bearing -arrow- in the crankshaft ⇒ En‐
gine; Rep. gr. 13 .
♦ Check whether the dowel sleeves for centering the gearbox
are present in the cylinder block, insert if necessary.
♦ If the gearbox is inserted, ensure the intermediate plate be‐
tween the engine and gearbox is correctly installed.
Vehicles with the rigid shafts (up to 11.2008)
•
Replace O-Rings -1- and circlips -2- to rigid shafts when a new
gearbox is to be fitted.
Continued for all vehicles
– Carefully raise gearbox with the engine/gearbox jack - V.A.G
1383 A- and put in its installation position using the spindles
of the gearbox mount - 3282- .
•
Carefully insert the selector lever control cable in the cable
support when raising the gearbox.
•
Do not bend or buckle selector lever control cable.
•
Observe all lines and coolant hoses when raising the gearbox.
– Adjust the gearbox mount - 3282- via the spindles in such a
way that the engine and the gearbox are aligned.
– Position the gearbox carefully onto the engine until the gear‐
box flange touches the entire scope of the engine flange, turn
the crankshaft where necessary.
– Screw on gearbox to the engine
⇒ "3.3 Tightening torques", page 169
Vehicles Octavia II, Superb II and Yeti
166
Rep. gr.34 - Controls, housing
.