Skoda FABIA II 2007 Workshop Manual page 1229

– Insert the gearbox console -1- between the gearbox and the
supporting arm of the gearbox mount.
– Screw the gearbox console -1- with new screws to the gear‐
box.
– Lift up the gearbox via the spindles of the supporting device -
MP9-200 (10-222 A)- to the supporting arm of the gearbox
mount.
Caution
Before screwing in the screws -arrows- the gearbox console
must be absolutely parallel to the supporting arm of the gear‐
box mount, otherwise the thread is damaged.
– Screw new screws -arrows- by hand initially and then tighten
to the specified tightening torque
⇒ "3.3 Tightening torques", page 169
For vehicles Fabia II, Roomster and Rapid NH
– Install the console at the gearbox with the fixing screws -1-.
– Raise the engine/gearbox assembly via spindles, align it in the
installation position, and install with new screws for the gear‐
box mount.
Continued for all vehicles
– Remove the gearbox mount - 3282- from the gearbox.
– Mount the right flange shaft
⇒ "1.5 Replacing the right flange shaft seal ring", page 188
– Install the left drive shaft and the right drive shaft ⇒ Chassis;
Rep. gr. 40 .
For vehicles Fabia II, Roomster and Rapid NH
– Install the assembly carrier ⇒ Chassis; Rep. gr. 40 .
– Screw the steering gear to the assembly carrier ⇒ Chassis;
Rep. gr. 48 .
Continued for all vehicles
– Install the pendulum support with new screws
-arrows B, and C- ⇒ Chassis; Rep. gr. 40 .
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 0AM-DSG - Edition 01.2015
.
3. Removing and installing the gearbox
167