Removing And Installing The Gearbox; Removing The Gearbox - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3

Removing and installing the gearbox

⇒ "3.1 Removing the gearbox", page 132
⇒ "3.2 Installing the gearbox", page 165
⇒ "3.3 Tightening torques", page 169
3.1

Removing the gearbox

⇒ "3.1.1 Removing the gearbox (Octavia II, Yeti)", page 132
⇒ "3.1.2 Remove gearbox (Superb II)", page 140
⇒ "3.1.3 Removing the gearbox (Fabia II, Roomster)",
page 148
⇒ "3.1.4 Removing gearbox (Rapid NH)", page 157
3.1.1 Removing the gearbox (Octavia II, Yeti)
Special tools and workshop equipment required
♦ Supporting device - T30099-
♦ Wedge - T10161-
♦ Hook for MP9-200 and T30099 - MP9-200/10 (10-222A/10)-
♦ Removal tool for the inner lining of the door panel -MP8-602/1-
♦ Gearbox mount - 3282-
♦ Bolt - 3282/29-
♦ Adjusting plate - 3282/59-
♦ Tensioning strap - T10038-
♦ Socket insert - T10107 A-
♦ Engine/gearbox jack , e.g. -V.A.G 1383 A-
♦ Spring strap clips , e.g. -VAS 6340-
♦ Socket insert , e.g. -T10035- or socket insert XZN 14 - T10061-
Observe instructions and safety instructions for automatic gear‐
box DSG - 0AM.
♦ ⇒ "2 Safety instructions", page 2
♦ ⇒ "3 Repair instructions", page 4
All cable straps which are detached or cut open when removing,
should be fitted on again in the same place when installing.
If the battery earth strap is disconnected and connected, carry out
additional operations ⇒ Electrical System; Rep. gr. 27 .
132
Rep. gr.34 - Controls, housing