Skoda FABIA II 2007 Workshop Manual page 1162

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
❑ Removing and installing handle as of 11.2012 (CW 45)
⇒ "2.6 Removing and installing handle for shift mechanism", page 112
❑ for the emergency release only the cover needs to be unclipped
⇒ "2.10 Emergency release of gearshift mechanism out of position P", page 127
❑ the symbol insert and the circuit board with the lamp for selector lever scale illumination - L101- are
integrated in the cover
3 - Cover with handle (Rapid NH)
❑ Removing and installing cover
⇒ "2.5 Removing and Installing the cover for the shift mechanism", page 109
❑ Removing and installing handle
❑ for the emergency release only the cover needs to be unclipped
⇒ "2.10 Emergency release of gearshift mechanism out of position P", page 127
❑ the symbol insert and the circuit board with the lamp for selector lever scale illumination - L101- are
integrated in the cover
4 - Open warm-type clamp
❑ Replace after disassembly
❑ tighten using hose binding claw - V.A.G 1275-
5 - Selector lever and shift mechanism
❑ with selector lever lock solenoid - N110-
❑ Emergency release
❑ Removing and installing
⇒ "2.8 Removing and installing shift mechanism with selector lever control cable", page 118
❑ after the installation adjust the selector lever control cable
⇒ "2.3 Inspecting and adjusting the selector lever control cable", page 105
❑ Remove the shift mechanism from the shift housing
6 - Screw
❑ 8 Nm
7 - Shift housing with gasket
❑ Remove shift housing
8 - Nut
❑ 4 pieces
❑ M6 - 8 Nm
❑ M8 - 25 Nm
9 - Gearshift lever
10 - Cable support
❑ for selector lever control cable
11 - Lock washer
❑ Replace after disassembly
12 - Selector lever control cable
❑ testing and adjusting
❑ The selector lever control cable must not be removed from the shift mechanism Pos. 5 and it must be
replaced together as one component part.
❑ Do not grease selector lever control cable
❑ remove from the shift housing and install
100
Rep. gr.34 - Controls, housing
⇒ "2.6 Removing and installing handle for shift mechanism", page 112
⇒ "2.10 Emergency release of gearshift mechanism out of position P", page 127
⇒ page 101
⇒ "2.3 Inspecting and adjusting the selector lever control cable", page 105
⇒ page 101
⇒ page 101