Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Insert the plastic support of the engaging levers and check for
correct fit.
Note
Only some older gearboxes have no clamp. New gearboxes al‐
ways have a clamp.
– Use two screws to install the small engaging lever with clamp.
•
The support of the engaging levers and the complete mecha‐
nism for the engaging bearings must be dry and free of oil or
grease.
•
If necessary, clean these component parts with a clean cloth.
– Insert the large engaging lever.
This larger engaging lever is for clutch K1.
– Check the correct fit of both engaging levers.
– Insert the small engaging bearing -A- for K2 with the measured
adjusting washer -B-.
Determine the thickness of the adjusting washer
⇒ "1.3 Adjust clutch release mechanism", page 41
The adjusting washer -B- belongs under the small engaging bear‐
ing -A-. Therefore, insert the adjusting washer first.
36
Rep. gr.30 - Clutch