Installing The Gearbox - Skoda FABIA II 2007 Workshop Manual

– Align arms of the gearbox mount - 3282- to match the holes in
the adjusting plate - 3282/59- .
– Screw in the mounting elements as shown on adjusting plate
- 3282/59- .
– Position the engine/gearbox jack - V.A.G 1383 A- below the
vehicle with the gearbox mount - 3282- .
• The arrow symbol on the adjusting plate - 3282/59- points in
the direction of travel.
– Align the gearbox mount - 3282- parallel to the gearbox.
– Screw the bolt - 3282/29- into the gearbox.
– Place both remaining mounting elements on the gearbox as
shown.
• To do so, place the panel of the drift under the gearbox hous‐
ing and not under the mechatronics.
– Secure the gearbox with the tensioning strap - T10038- .
– Support the gearbox with engine/gearbox jack - V.A.G 1383
A- from underneath.
– Unscrew the last connecting screw -arrow- at engine and
gearbox.
– Separate the gearbox from the engine and carefully lower it.
– When lowering the gearbox, guide the selector lever control
cable out of the cable support.
Caution
Observe all lines and coolant hoses when lowering the gear‐
box.
Do not bend or buckle selector lever control cable.
Vehicles with flange shafts (as of 11.2008)
– Reinstall the right flange shaft.
Continued for all vehicles
In some cases, they are installed at the front holder on the gear‐
box.
Note
If a new gearbox is installed, the holders must be modified to the
new gearbox. holder
Transport the gearbox and secure it to the assembly stand
⇒ "4 Transport the gearbox and secure to the assembly support",
page 172 .
3.2

Installing the gearbox

Installation is carried out in reverse order of removal. When in‐
stalling, note the following:
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3. Removing and installing the gearbox
165