Removing And Installing The Cover For The Shift Mechanism - Skoda FABIA II 2007 Workshop Manual

Note
Up to 10.2011, this condition is not valid for the vehicles Fabia ll
and Roomster, where there is no ignition key anti-removal lock
and the key can be withdrawn in any selector lever position. On
all vehicles as of 11.2011, the key cannot be withdrawn in any
selector lever position, except position P.
– Shift selector lever into position P.
– Withdraw ignition key.
• Only withdraw the key from the ignition starter switch if the
selector lever is in position P.
• The selector lever cannot be shifted out of position P when the
button is pressed and the brake pedal is actuated.
If the ignition key removal lock does not function as described:
♦ Inspecting and adjusting the selector lever control cable
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 105 .
♦ Check the vehicle with the vehicle diagnosis, measurement
and information system - VAS/ODIS- in the function "targeted
fault finding".
2.5 Removing and Installing the cover for
the shift mechanism
Special tools and workshop equipment required
♦ Unlocking tool - T30098- (Octavia II, Superb II, Yeti, Rapid NH)
♦ Disassembly wedge - 3409- (Fabia II, Roomster)
Note
As of 11.2012 (CW 45), the selector lever was changed:
Removing
– Push selector lever to position N.
– Switch off ignition.
– Open ashtray in the centre console (if required).
Vehicles Octavia II and Yeti
– Use the release tool - T30098- to unlock the cover at front right
-arrow-, then rear right and centre -arrow-, in stages.
Vehicles Superb II
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
2. Shift mechanism
109