Skoda FABIA II 2007 Workshop Manual page 1102

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
In the installation position, the openings of the guide bushing bot‐
tom part lie vertically to the engaging lever and the sleeve can be
moved freely at the same time.
– Insert the small engaging lever with the top and bottom part of
the guide bushing and tighten the screws.
– Insert the second, larger engaging lever with the measured
adjusting washers for clutch K1 and K2.
The large adjusting washer for the clutch K1 is inserted with the
semispherical side downwards on the large bearing, the small
adjusting washer for the clutch K2 is inserted under the small
bearing.
The small engaging bearing and the adjusting washer fit in only
one position due to the 8 grooves.
– Insert the small engaging bearing.
– While turning the bearing, check if it is correctly installed and
the grooves are correctly positioned.
– Check the correct fit of both engaging levers.
Specified torques
♦ Small engaging lever on gearbox
⇒ "1.1.2 Summary of components - Clutch release mecha‐
nism, version as of 06.2011", page 33
40
Rep. gr.30 - Clutch