Removing And Installing The Tiptronic Switch F189; Removing And Installing Selector Lever Lock Solenoid N110; Removing And Installing Selector Lever Switch Locked In P F319; Removing And Installing The Selector Lever Sensor Control Unit J587 - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Depress the brake pedal or pull on the handbrake.
– Press the yellow plastic wedge -A- in -direction of arrow 1-.
– Now press the button on the selector lever handle and shift the
selector lever -B- in -direction of arrow 2- out of the position P.
Note
If the selector lever is then shifted again into the position P, it is
locked again in position P.
2.11 Removing and installing the Tiptronic
switch - F189-
The Tiptronic switch - F189- is integrated firmly in the gearshift
mechanism and cannot be replaced separately.
If the Tiptronic switch - F189- is defective, the gearshift mecha‐
nism must be replaced
⇒ "2.8 Removing and installing shift mechanism with selector lev‐
er control cable", page 118
2.12 Removing and installing selector lever
lock solenoid - N110-
The selector lever lock solenoid - N110- is integrated firmly in the
gearshift mechanism and cannot be replaced separately.
If the selector lever lock solenoid - N110- is defective, the gear‐
shift mechanism must be replaced
⇒ "2.8 Removing and installing shift mechanism with selector lev‐
er control cable", page 118
2.13 Removing and installing selector lever
switch locked in P - F319-
The selector lever switch locked in P - F319- is integrated firmly
in the gearshift mechanism and cannot be replaced separately.
If the selector lever switch locked in P - F319- is defective, the
gearshift mechanism must be replaced
⇒ "2.8 Removing and installing shift mechanism with selector lev‐
er control cable", page 118
2.14 Removing and installing the selector
lever sensor control unit - J587-
Selector lever sensor control unit - J587- is integrated firmly in the
gearshift mechanism and cannot be replaced separately.
If the selector lever sensor control unit - J587- is defective, the
gearshift mechanism must be replaced
⇒ "2.8 Removing and installing shift mechanism with selector lev‐
er control cable", page 118
130
Rep. gr.34 - Controls, housing
.
.
.
.