Skoda FABIA II 2007 Workshop Manual page 1209

– Then lower the engine and gearbox via the spindles of the
supporting device - MP9-200 (10-222 A)- as far as necessary
so that there is a gap of dimension -a- between the gearbox
console and the gearbox mount.
• Dimension -a- = 60 ... 70 mm.
– Screw out screws -arrows- and remove gearbox console.
The gearbox mount - 3282- is placed on the engine/gearbox jack
- V.A.G 1383 A- and is aligned using the adjusting plate - 3282/59-
to remove the gearbox.
– Align arms of the gearbox mount - 3282- to match the holes in
the adjusting plate - 3282/59- .
– Screw in the mounting elements as shown on adjusting plate
- 3282/59- .
– Position the engine/gearbox jack - V.A.G 1383 A- below the
vehicle with the gearbox mount - 3282- .
• The arrow symbol on the adjusting plate - 3282/59- points in
the direction of travel.
– Align the gearbox mount - 3282- parallel to the gearbox.
– Screw the bolt - 3282/29- into the gearbox.
– Place both remaining mounting elements on the gearbox as
shown.
• To do so, place the panel of the drift under the gearbox hous‐
ing and not under the mechatronics.
– Secure the gearbox with the tensioning strap - T10038- .
– Support the gearbox with engine/gearbox jack - V.A.G 1383
A- from underneath.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
3. Removing and installing the gearbox
147