Configure Snmp Trap Group - ZyXEL Communications XS3800-28 User Manual

28-port 10gbe l3 managed switch

Hide thumbs Also See for XS3800-28:

Table of Contents

Table 72 SYSTEM > SNMP > SNMP User > Add/Edit (continued)

26.4 Configure SNMP Trap Group

Use this screen to specify the types of SNMP traps that should be sent to each SNMP manager. Click

SYSTEM > SNMP > SNMP Trap Group to view the screen as shown.

Figure 130 SYSTEM > SNMP > SNMP Trap Group

The following table describes the labels in this screen.

Table 73 SYSTEM > SNMP > SNMP Trap Group

Trap Destination IP

Chapter 26 SNMP

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to

save your changes to the non-volatile memory when you are done configuring.

Click Clear to clear the fields to the factory defaults.

Click Cancel to not save the configuration you make and return to the last screen.

Select one of your configured trap destination IP addresses. These are the IP addresses of the

SNMP managers. You must first configure a trap destination IP address in the SYSTEM > SNMP >

SNMP screen.

Use the rest of the screen to select which traps the Switch sends to that SNMP manager.

Select the individual SNMP traps that the Switch is to send to the SNMP station.

The traps are grouped by category. Selecting a category in the heading row automatically

selects all of the SNMP traps under that category. Clear the check boxes for individual traps

that you do not want the Switch to send to the SNMP station. Clearing a category's check

box automatically clears all of the category's trap check boxes (the Switch only sends traps

from selected categories).

XS3800-28 User's Guide