Link Aggregation Control Protocol - ZyXEL Communications GS1915 Series User Manual

Table 71 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Apply
Cancel

17.3.1 Link Aggregation Control Protocol

Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen
shown next. See
aggregation.
Figure 111 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 72 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
Link
Aggregation
Control
Protocol
Active
Chapter 17 Link Aggregation
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Dynamic Link Aggregation on page 152
DESCRIPTION
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Select this check box to enable Link Aggregation Control Protocol (LACP).
GS1915 Series User's Guide
for more information on dynamic link
156