Table of Contents
Advertisement
The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 155 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
38.3.1 Configuring DSCP Settings
To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the DiffServ screen to display the
screen as shown next.
Figure 202 IP Application > DiffServ > DSCP Setting
The following table describes the labels in this screen.
Table 156 IP Application > DiffServ > DSCP Setting
LABEL
DESCRIPTION
0 ... 63
This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Apply
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Chapter 38 Differentiated Services
0 – 7
8 – 15
16 – 23
0
1
2
MES3500-24S/MGS3520 Series User's Guide
24 – 31
32 – 39
40 – 47
3
4
5
319
48 – 55
56 – 63
6
7
Advertisement
Table of Contents
Troubleshooting
