Configuring Dscp Settings - ZyXEL Communications XMG1930-30 User Manual

48.3.1 Configuring DSCP Settings

To change the DSCP-IEEE 802.1p mapping click SWITCHING > QoS > Diffserv > DSCP Setting to display the
screen as shown next.
Figure 232 SWITCHING > QoS > Diffserv > DSCP Setting
The following table describes the labels in this screen.
Table 173 SWITCHING > QoS > Diffserv > DSCP Setting
LABEL DESCRIPTION
0 ... 63 This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your changes to
the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Chapter 48 Differentiated Services
XMG1930 Series User's Guide
336