Juniper SRX5400 Hardware Manual page 102

SRX5400 Services Gateway Hardware Guide
SRX5400 Services Gateway Card Terminology
Related
Documentation
Holding an SRX5400 Services Gateway Card
88
Regardless of orientation, this information uses the same terms for all four edges of the
card:
Faceplate—Edge of the card that has connectors to which you connect cables or
sockets in which you insert transceivers.
Connector edge—Edge opposite the faceplate; this edge has the connectors that attach
to the midplane.
Top edge—Edge at the top of the card when it is vertical.
Bottom edge—Edge at the bottom of the card when it is vertical.
NOTE: This terminology applies to SPCs, MPCs, and SCB in addition to
Routing Engines and MICs.
Routine Maintenance Procedures for the SRX5400 Services Gateway on page 81
Tools and Parts Required to Maintain the SRX5400 Services Gateway on page 81
Holding an SRX5400 Services Gateway Card on page 88
Storing an SRX5400 Services Gateway Card on page 90
When carrying a card, you can hold it either vertically or horizontally.
NOTE: A card weighs up to 18.3 lb (8.3 kg). Be prepared to accept the full
weight of the card as you lift it.
To hold a card vertically:
Orient the card so that the faceplate faces you. To verify orientation, confirm that the
1.
text on the card is right-side up and the EMI strip is on the right-hand side.
Place one hand around the card faceplate about a quarter of the way down from the
2.
top edge. To avoid deforming the EMI shielding strip, do not press hard on it.
Place your other hand at the bottom edge of the card.
3.
If the card is horizontal before you grasp it, place your left hand around the faceplate and
your right hand along the bottom edge.
To hold a card horizontally:
Orient the card so that the faceplate faces you.
1.
Grasp the top edge with your left hand and the bottom edge with your right hand.
2.
Copyright © 2014, Juniper Networks, Inc.