Juniper SRX5400 Hardware Manual page 227

Removing the Fan Tray Before Installing an SRX5400 Services Gateway Without a Lift
Copyright © 2014, Juniper Networks, Inc.
Appendix F: Installing the SRX5400 Services Gateway Without a Mechanical Lift
Loosen the captive screws on the bottom edge of the power supply faceplate.
3.
Pull the power supply straight out of the chassis.
4.
Figure 71: Removing a Power Supply Before Installing the Device
To remove the fan tray (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the captive screws on the fan tray faceplate.
2.
Grasp the fan tray handle and pull it out approximately 1 to 3 inches.
3.
Press the latch located on the inside of the fan tray to release it from the chassis.
4.
Place one hand under the fan tray to support it and pull the fan tray completely out
5.
of the chassis.
Figure 72 on page 214 ):
213