Juniper SRX5400 Hardware Manual page 68

SRX5400 Services Gateway Hardware Guide
54
Using the lift, position the services gateway in front of the rack or cabinet, centering
3.
it in front of the mounting shelf.
Lift the chassis approximately 0.75 in. above the surface of the mounting shelf and
4.
position it as close as possible to the shelf.
Carefully slide the services gateway onto the mounting shelf so that the bottom of
5.
the chassis and the mounting shelf overlap by approximately two inches.
Slide the device onto the mounting shelf until the mounting brackets contact the rack
6.
rails. The shelf ensures that the holes in the mounting brackets of the chassis align
with the holes in the rack rails.
Move the lift away from the rack.
7.
Install a mounting screw into each of the open mounting holes aligned with the rack,
8.
starting from the bottom.
Visually inspect the alignment of the services gateway. If the services gateway is
9.
installed properly in the rack, all the mounting screws on one side of the rack should
be aligned with the mounting screws on the opposite side and the device should be
level.
Figure 21: Installing the Services Gateway in the Rack
NOTE: This illustration depicts the services gateway being installed in an
open-frame rack.
Copyright © 2014, Juniper Networks, Inc.