Installing An Srx5400 Services Gateway Transceiver - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide

Installing an SRX5400 Services Gateway Transceiver

136
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Pull the ejector handle out from the transceiver to unlock the transceiver.
6.
CAUTION: Make sure that you open the ejector handle completely until
you hear it click. This prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
Grasp the transceiver ejector handle and pull the transceiver approximately 0.5 in. (1.3
7.
cm) out of the card.
Using your fingers, grasp the body of the transceiver and pull it the rest of the way out
8.
of the card.
Figure 56: Removing a Transceiver
Place a rubber safety cap over the transceiver.
9.
Place the removed transceiver on an antistatic mat or in an electrostatic bag.
10.
CAUTION: After removing a transceiver from the card, wait at least 30
seconds before reinserting it or inserting a transceiver into a different socket.
Transceivers that are installed in an MIC or SPC. Transceivers are hot-insertable and
hot-removable. Removing a transceiver does not interrupt the functioning of the card,
but the removed transceiver no longer receives or transmits data.
Copyright © 2014, Juniper Networks, Inc.