Step 6: Connect Power Cables; Connect Power To An Ac-Powered Services Gateway - Juniper SRX5400 Getting Started Manual

CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
CAUTION:
the fastened loops of a cable to dangle, which stresses the cable at the fastening point.
Proceed to "Step 6: Connect Power Cables" on page

Step 6: Connect Power Cables

IN THIS SECTION

Connect Power to an AC-Powered Services Gateway | 18

Connect Power to a DC-Powered Services Gateway | 20
Depending on its configuration, the services gateway uses either AC or DC power supplies. Perform the
appropriate procedures for each power supply in the services gateway.
Connect Power to an AC-Powered Services Gateway
WARNING:
to ensure proper operation, you must properly ground the services gateway chassis
before connecting power. See
instructions.
Avoid bending a fiber-optic cable beyond its minimum bend radius. An
Do not let fiber-optic cables hang free from the connector. Do not allow
To meet safety and electromagnetic interference (EMI) requirements and
"Step 4: Connect the Grounding Cable" on page 14
18.
18
for