Juniper SRX5400 Hardware Manual page 234

SRX5400 Services Gateway Hardware Guide
Reinstalling Cards After Installing the SRX5400 Services Gateway Without a Lift
Related
Documentation
220
To reinstall MPCs, SPCs, and the SCB, follow this procedure for each card (see
Figure 77 on page 220):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Place the card on an antistatic mat or remove it from its electrostatic bag.
2.
Identify the slot on the services gateway where it will be installed.
3.
Verify that each fiber-optic has a rubber safety cap covering the transceiver. If it does
4.
not, cover the transceiver with a safety cap.
Orient the card so that the faceplate faces you.
5.
Lift the card into place and carefully align the sides of the card with the guides inside
6.
the card cage.
Slide the card all the way into the card cage until you feel resistance.
7.
Grasp both ejector handles and rotate them clockwise simultaneously until the card
8.
is fully seated.
Figure 77: Installing an MPC or SPC
Overview of Installing the SRX5400 Services Gateway Without a Mechanical Lift on
page 211
Tools Required to Install the SRX5400 Services Gateway Without a Mechanical Lift
on page 212
Removing Components from the SRX5400 Chassis Before Installing It Without a Lift
on page 212
Installing the SRX5400 Services Gateway Chassis in the Rack Manually on page 216
Copyright © 2014, Juniper Networks, Inc.