Juniper SRX5400 Hardware Manual page 75

Related
Documentation
Connecting Network Cables to SRX5400 Services Gateway MICs
Copyright © 2014, Juniper Networks, Inc.
Figure 27: Connecting an External Alarm-Reporting Device
Attach the other end of the wires to the external device.
4.
To attach a reporting device for the other kind of alarm, repeat the procedure.
Tools and Parts Required for SRX5400 Services Gateway Connections on page 57
Overview of Installing the SRX5400 Services Gateway on page 33
Connecting the SRX5400 Services Gateway to a Network for Out-of-Band Management
on page 58
Connecting the SRX5400 Services Gateway to a Management Console or an Auxiliary
Device on page 59
Connecting the SRX5400 Services Gateway to a Network for Out-of-Band Management
on page 58
Connecting Network Cables to SRX5400 Services Gateway MICs on page 61
To connect the MICs to the network:
Have ready a length of the type of cable used by the component.
1.
Remove the rubber safety plug from the cable connector port.
2.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
Chapter 8: Connecting the SRX5400 Services Gateway
61