Juniper SRX5400 Hardware Manual page 64

SRX5400 Services Gateway Hardware Guide
Related
Documentation
Moving the Mounting Brackets for Center-Mounting the SRX5400 Services Gateway
50
Figure 20: Installing the Mounting Hardware for an Open-Frame Rack
Tools and Parts Required to Install the SRX5400 Services Gateway Mounting Hardware
for a Rack or Cabinet on page 47
Overview of Installing the SRX5400 Services Gateway on page 33
Site Preparation Checklist for the SRX5400 Services Gateway on page 35
Unpacking the SRX5400 Services Gateway on page 43
Moving the Mounting Brackets for Center-Mounting the SRX5400 Services Gateway
on page 50
Two removable mounting brackets are attached to the mounting holes closest to the
front of the chassis. You can move the pair of brackets to another position on the side of
the chassis for center-mounting the services gateway.
To move the mounting brackets from the front of the chassis toward the center of the
chassis:
Remove the three screws at the top and center of the bracket.
1.
Pull the top of the bracket slightly away from the chassis. The bottom of the bracket
2.
contains a tab that inserts into a slot in the chassis.
Pull the bracket away from the chassis so that the tab is removed from the chassis
3.
slot.
Copyright © 2014, Juniper Networks, Inc.