Powering On A Dc-Powered Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

SRX5400 Services Gateway Hardware Guide
Related
Documentation

Powering On a DC-Powered SRX5400 Services Gateway

70
Figure 31: Connecting DC Power to the Device
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway on
page 155
Overview of Installing the SRX5400 Services Gateway on page 33
Tools and Parts Required for SRX5400 Services Gateway Grounding and Power
Connections on page 63
Grounding the SRX5400 Services Gateway on page 64
Powering On a DC-Powered SRX5400 Services Gateway on page 70
Powering Off the SRX5400 Services Gateway on page 72
To power on a DC-powered services gateway:
Verify that an external management device is connected to one of the Routing Engine
1.
ports ( , , or
AUX CONSOLE
Turn on the power to the external management device.
2.
Verify that the power supplies are fully inserted in the chassis.
3.
Verify that the source power cables are connected to the appropriate terminal: the
4.
positive (+) source cable to the return terminal (labeled
(–) source cable to the input terminal (labeled
Switch on the dedicated customer site circuit breakers to provide power to the DC
5.
power cables. Follow your site's procedures.
Check the LED is lit steadily green to verify that power is present.
6. INPUT OK
).
ETHERNET
–48V
Copyright © 2014, Juniper Networks, Inc.
) and the negative
RETURN
).