Ac Power Cord Specifications For The Srx5400 Services Gateway - Juniper SRX5400 Hardware Manual

AC Power Circuit Breaker Requirements for the SRX5400 Services Gateway
Related
Documentation

AC Power Cord Specifications for the SRX5400 Services Gateway

Table 31: AC Power Cord Specifications
Country Model Number
Australia CBL-M-PWR-RA-AU
China CBL-M-PWR-RA-CH
Europe (except CBL-M-PWR-RA-EU
Denmark, Italy,
Switzerland, and
United Kingdom)
Italy CBL-M-PWR-RA-IT
Copyright © 2014, Juniper Networks, Inc.
Appendix C: SRX5400 Services Gateway Power Guidelines, Requirements, and Specifications
AC Power Circuit Breaker Requirements for the SRX5400 Services Gateway on page 195
AC Power Cord Specifications for the SRX5400 Services Gateway on page 195
Each AC power supply has a single AC appliance inlet located on the power supply that
requires a dedicated AC power feed. We recommend that you use a customer site circuit
breaker rated for 15 A (250 VAC) minimum for each AC power supply, or as required by
local code. Doing so enables you to operate the services gateway in any configuration
without upgrading the power infrastructure.
Calculating Power Requirements for the SRX5400 Services Gateway on page 189
SRX5400 Services Gateway AC Power Supply Specifications on page 194
AC Power Cord Specifications for the SRX5400 Services Gateway on page 195
Each AC power supply has a single AC appliance inlet located on the power supply that
requires a dedicated AC power feed. Most sites distribute power through a main conduit
that leads to frame-mounted power distribution panels, one of which can be located at
the top of the rack that houses the services gateway. An AC power cord connects each
power supply to the power distribution panel.
The services gateway is not shipped with AC power cords. You must order power cords
separately using the model number shown in
coupler at the female end of the cord inserts into the AC appliance inlet coupler, type
C20 (right angle) as described by International Electrotechnical Commission (IEC)
standard 60320. The plug at the male end of the power cord fits into the power source
receptacle that is standard for your geographical location.
Table 31 on page 195 provides specifications and
on the AC power cord provided for each country or region.
Table 31 on page
Figure 68 on page 196
Electrical Specification
240 VAC, 50 Hz AC
220 VAC, 50 Hz AC
220 or 230 VAC, 50 Hz AC
230 VAC, 50 Hz AC
195. The C19 appliance
depicts the plug
Plug Type
SAA/3/15
CH2-16P
CEE 7/7
CEI 23-16/VII
195