Appendix A Safety And Regulatory Compliance Information; Srx5400 Services Gateway General Safety Guidelines And Warnings - Juniper SRX5400 Hardware Manual

Related
Documentation

SRX5400 Services Gateway General Safety Guidelines and Warnings

Copyright © 2014, Juniper Networks, Inc.
måste du vara medveten om farorna med elkretsar och känna till vanligt
förfarande för att förebygga skador.
SRX5400 Services Gateway General Safety Guidelines and Warnings on page 151
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway on
page 155
SRX5400 Services Gateway Fire Safety Requirements and Fire Suppression Equipment
on page 156
The following guidelines help ensure your safety and protect the services gateway from
damage. The list of guidelines might not address all potentially hazardous situations in
your working environment, so be alert and exercise good judgment at all times.
Perform only the procedures explicitly described in this guide. Make sure that only
authorized service personnel perform other system services.
Keep the area around the chassis clear and free from dust before, during, and after
installation.
Keep tools away from areas where people could trip on them.
Do not wear loose clothing or jewelry, such as rings, bracelets, or chains, which could
become caught in the chassis.
Wear safety glasses if you are working under any conditions that could be hazardous
to your eyes.
Do not perform any actions that create a potential hazard to people or that make the
equipment unsafe.
Never attempt to lift an object that is too heavy for one person to handle.
Never install or manipulate wiring during electrical storms.
Never install electrical jacks in wet locations unless the jacks are specifically designed
for wet environments.
Operate the services gateway only when it is properly grounded.
Do not open or remove chassis covers or sheet metal parts unless instructions are
provided in this guide. Such an action could cause severe electrical shock.
Do not push or force any objects through any opening in the chassis frame. Such an
action could result in electrical shock or fire.
Appendix A: Safety and Regulatory Compliance Information
151