Juniper SRX5400 Hardware Manual page 142

SRX5400 Services Gateway Hardware Guide
128
In the example below, all redundancy groups are primary on node 0, and secondary
on node 1:
admin@cluster> show chassis cluster status
Cluster ID: 1
Node Priority
Redundancy group: 0 , Failover count: 5
node0 1
node1 100
Redundancy group: 1 , Failover count: 1
node0 200
node1 100
Redundancy group: 2 , Failover count: 1
node0 200
node1 100
Redundancy group: 3 , Failover count: 1
node0 100
node1 200
Redundancy group: 4 , Failover count: 1
node0 200
node1 100
If the device with which you established the CLI session in Step
3.
node in the cluster, use the console port on the device that is the secondary node to
establish a CLI session.
In the CLI session for the secondary services gateway, issue the request system power
4.
off command to shut down the services gateway.
Wait for the secondary services gateway to completely shut down.
5.
Install the new MPCs in the powered-off services gateway using the procedure in
6.
"Installing an SRX5400 Services Gateway MPC" on page
Install MICs in the MPCs in the powered-off services gateway using the procedure in
7.
"Installing an SRX5400 Services Gateway MIC" on page
Power on the secondary services gateway and wait for it to finish starting.
8.
Reestablish the CLI session with the secondary node device.
9.
Issue the show chassis fpc pic-status command to make sure that all of the cards
10.
in the secondary node chassis are back online. For example:
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
Slot 1 Online
PIC 0 Online
PIC 1 Online
Status Preempt Manual failover
primary no no
secondary no no
primary no no
secondary no no
primary no no
secondary no no
primary no no
secondary no no
primary no no
secondary no no
SRX5k SPC II
SPU Cp
SPU Flow
SPU Flow
SPU Flow
SRX5k SPC II
SPU Flow
SPU Flow
2 is not the secondary
122.
126.
Copyright © 2014, Juniper Networks, Inc.