Juniper SRX5400 Hardware Manual page 33

SRX5400 Services Gateway Craft Interface Fan LEDs
Related
Documentation
SRX5400 Services Gateway Craft Interface Online/Offline Buttons
Copyright © 2014, Juniper Networks, Inc.
The fan tray LED are located near the middle of the craft interface.
describes the functions of the fan tray LEDs.
Table 10: Fan LEDs
Label Color
Green
OK
Red
FAIL
SRX5400 Services Gateway Craft Interface Overview on page 15
SRX5400 Services Gateway Craft Interface Card OK/Fail LEDs on page 18
SRX5400 Services Gateway Craft Interface Online/Offline Buttons on page 19
The craft interface has a row of Online/Offline buttons along its lower edge. Each button
corresponds to one slot in the card cage. The Online/Offline buttons are only supported
for slots containing MPC interface cards. You can install MPCs into slots
NOTE: The Online/Offline buttons are not supported for removal and
replacement of SPCs or SCB.
CAUTION: While traffic is passing through the SRX5400 Services Gateway,
particularly if the device is configured as part of a high availability (HA) cluster,
we strongly recommend that you do not push any of the Online/Offline
buttons.
To take an MPC offline using the Online/Offline buttons:
Press and hold the corresponding card's Online/Offline button on slot
1.
interface. The green
OK/FAIL
the button's LED and the MPC's LED are off.
Issue the CLI
2. show chassis fpc
shown in the sample output, the value Offline in the column labeled State indicates
that the MPC in slot is now offline:
1
user@host> show chassis fpc
Slot State
0 Online
1 Online
2 Online
Chapter 2: SRX5400 Services Gateway Hardware Components
State
On steadily
On steadily
LED next to the button begins to blink. Hold until both
command to check the status of installed MPCs. As
(C) Total Interrupt
35 4 0
47 3 0
37 8 0
Table 10 on page 19
Description
Fan tray is functioning normally.
Fan tray has failed.
, , and
0/1 1 2
on the craft
1
DRAM (MB) Heap Buffer
1024 13
1024 13
2048 18
only.
25
25
14
19