Juniper SRX5400 Hardware Manual page 133

Related
Documentation
Replacing the SRX5400 Services Gateway Console or Auxiliary Cable
Copyright © 2014, Juniper Networks, Inc.
Plug one end of the replacement cable into the
4.
shows the port.
Plug the other end of the cable into the network device.
5.
Figure 46: Cable Connector
Figure 47: Ethernet Port
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway on
page 155
Replacing the SRX5400 Services Gateway Routing Engine on page 116
Replacing the SRX5400 Services Gateway Console or Auxiliary Cable on page 119
To use a system console to configure and manage the Routing Engine, connect it to the
port on the Routing Engine. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the AUX port on the Routing Engine. Both ports accept a cable with an RJ-45
connector. One RJ-45/DB-9 cable is provided with the services gateway. If you want to
connect a device to both ports, you must supply another cable.
To replace a cable connected to a management console or auxiliary device:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Press the tab on the connector and pull the connector straight out of the port.
2.
Disconnect the cable from the console or auxiliary device.
3.
Plug the RJ-45 end of the replacement serial cable into the
4.
Figure 48 on page 120 shows the external device ports on the Routing Engine.
Plug the female DB-9 end into the console or auxiliary device's serial port.
5.
Chapter 13: Replacing SRX5400 Services Gateway Hardware Components
ETHERNET
port. Figure 47 on page 119
or port.
CONSOLE AUX
119